Note: Due to the amount of SPAM received in the forums and to better serve our customers, support is now done by sending a message using the "Contact" link above . This forum is set to read-only, but you can still search the forum.

Zap Weather Questions and Comments

TOPIC: Bad service input(s)

Bad service input(s) 10 years 9 months ago #4248

  • TupeloWx
  • TupeloWx's Avatar
  • OFFLINE
  • Senior Boarder
  • Posts: 42
  • Karma: 0
Has anyone encountered this? I just installed the new version of Zap Weather and after setting up my current location using the same settings as with the old version, this is the output from the module;
Bad service input(s)

Array
(
[lat] =>
[lon] =>
[format] => 24 hourly
[startDate] => 2013-07-15T17:25
)
The administrator has disabled public write access.

Bad service input(s) 10 years 9 months ago #4250

  • TupeloWx
  • TupeloWx's Avatar
  • OFFLINE
  • Senior Boarder
  • Posts: 42
  • Karma: 0
I should have included that this is on a brand new installation of Joomla 2.5.11. I have uninstalled Zap Weather and reinstalled a second and with the built-in sample data I still get the same error. I'm scratching my head....
The administrator has disabled public write access.

Bad service input(s) 10 years 9 months ago #4255

  • Codeman91
  • Codeman91's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 4
  • Karma: 0
I just installed Zap Weather 8 and set it up as a module. When I try to display the module, I get a "Bad Service Input(s)" error with the following:

Array
(
[lat] =>
[lon] =>
[format] => 24 hourly
[startDate] => 2013-07-17T15:11
)

Am I doing something wrong? I've tried both the pre-existing entries in the Zap Weather location manager and an entry I put in, and all get the same error.
The administrator has disabled public write access.

Bad service input(s) 10 years 9 months ago #4261

  • cogliano
  • cogliano's Avatar
  • OFFLINE
  • Moderator
  • Posts: 1854
  • Thank you received: 58
  • Karma: 29
Do you have a location selected in the module? There is no lat/lng data there, which there should be. Or, check the location you have selected to verify the lat/lng data has been defined.
The administrator has disabled public write access.

Bad service input(s) 10 years 9 months ago #4262

  • Codeman91
  • Codeman91's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 4
  • Karma: 0
I have a location selected, and it has lat/lon data associated with it.
The administrator has disabled public write access.

Bad service input(s) 10 years 9 months ago #4263

  • TupeloWx
  • TupeloWx's Avatar
  • OFFLINE
  • Senior Boarder
  • Posts: 42
  • Karma: 0
I have tried both as well - the original data on a fresh installation and also setting up multiple locations, all with the same results. The error always shows lat and lon blank even though those are set up.
The administrator has disabled public write access.
Time to create page: 0.081 seconds
Powered by Kunena Forum